Woody’s® carbide carries innovative features like 60° carbide inserts that are guaranteed not to come out under any conditions, Flat-Top design, rounded wear pads, full-length hardweld and bevel-cut host bar that doesn’t snag trailer edge. Superior quality, construction, performance, safety and reduced expense due to long service life – the Woody’s guarantee.
FLAT-TOP RUNNER DESIGN: Woody’s Flat-Top design creates a larger contact area with the ski than a round host bar. The result is greater support, which means less flexing and rocking, with greater steering agility for the driver.
WEAR PAD DESIGN: Most Woody’s carbide runners feature carbide wear pads with a rounded surface. The rounded surface is less likely to catch an edge on the trail or on your trailer. (Some models require drilling extra holes in ski).
ULTRA™ 1 1/2” CARBIDE 10” CARBIDE 1 1/2” CARBIDE
Designed for the most aggressive trail riding
5/8” host runner features a full 10” of 60° turning carbide
Carbide wear pads are used throughout the entire bar for longer life
For use with OEM composite ski; track studding required
Sold in pairs
1/2” thick with flat-top design, extended mount studs and a rear angle cut
Sold in pairs
EXECUTIVE SERIES™ FLAT-TOP
Designed for aggressive trail riders and racers
1/2” diameter host runner features a full 8” of 60° sharp edge turning carbide
1 1/2” carbide wear pads front and rear and full-length hardweld surfaces between all three carbide inserts ensure extended wear
Extra-long studs make it easy to install plastic ski skins
Track studding required
Sold in pairs
TRAIL BLAZER IV™ FLAT-TOP
Designed for aggressive trail riders
Excellent high-speed cornering control
1/2” host runner features 6” of 60° sharp edge turning carbide
Wear pads are a full 1 1/2” long
Full-length hardweld surfaces between all three carbide inserts provide extended wear
Extra-long studs make it easy to install plastic ski skins
Track studding recommended
Sold in pairs
EXTENDER TRAIL III™ FLAT-TOP
Woody’s most popular carbide
7/16” host bar carries 4” turning carbide that has a sharp 60° edge angle for performance cornering; 1 1/2” carbide wear pads help extend runner life
Full-length hardweld surfaces between all three carbide inserts for total wear protection
Extra-long studs make it easy to mount plastic ski skins
Sold in pairs
TOP-STOCK™ HARD SURFACE BAR
A hardweld runner designed for extreme service or utility applications
1/2” host bar with a double bead of hardweld increases the depth of the runner for controllability in grass racing or deep snow conditions
Not recommended to replace OEM carbide runners; not suitable for sleds with over 48 installed studs in track
1/2” thick with flat-top design, extended mount studs and a rear angle cut
